Pair your iPhone or iPad with your Bluetooth accessories to stream music and videos, make phone calls and more.
Depending on the apps you're using, you may see an alert that says you need to enable Bluetooth before you can pair an accessory with Bluetooth.
After you've paired your accessory, you can use it with your device. To pair multiple Bluetooth accessories, repeat these steps. If you have multiple Bluetooth devices paired with your iPhone or iPad, you can choose which audio source you want to use.
To unpair a Bluetooth accessory, go to Settings > Bluetooth, find the device you want to unpair, tap the More Info button , then tap Forget this Device. This will remove the accessory from the list of available Bluetooth devices.To add the Bluetooth accessory to your device again, place it back in discovery mode and repeat the steps to pair your device. Information about products not manufactured by Apple, or independent websites not controlled or tested by Apple, is provided without recommendation or endorsement. Apple assumes no responsibility with regard to the selection, performance or use of third-party websites or products. Apple makes no representations regarding third-party website accuracy or reliability. Contact the vendor for additional information.
The speaker can be paired with up to 8 BLUETOOTH devices. When pairing with two or more BLUETOOTH devices, perform the following pairing procedure for each device. Before operating the speaker, be sure to do the following:
Hint
Note
Article ID : 00191881 / Last Modified : 09/22/2022 IMPORTANT: This article applies only to specific products and/or operating systems. Check Applicable Products and Categories for details. 1. Check the followingDepending on the conditions, the sound may skip or break up. Check the following.
If none of these apply, proceed to the next step. Note: If you connect the speaker to a computer for phone call use, go to the 3. Check the connection status between the devices section. 2. Change the wireless playback quality of the speakerUse the following method to change the wireless playback quality of the speaker to Priority on stable connection. SRS-XB20, SRS-XB21, SRS-XB22, SRS-XB30, SRS-XB31, SRS-XB32, SRS-XB40, SRS-XB41
SRS-XB23, SRS-XB33, SRS-XB43
Notes:
GTK-XB60, GTK-XB90
It may also be possible to configure the playback quality on your Walkman® player or Xperia® phone. Confirm the specifications and operating method of your device. SRS-XB12
It may also be possible to configure the playback quality on your Walkman or Xperia. Confirm the specifications and operating method of your device. SRS-XB13, SRS-XE200, SRS-XE300, SRS-XG300
SRS-XV900
While battery charging of the neckband speaker is in progress, press and hold the play/call button and the microphone off button simultaneously for about two seconds.When the selection of the Priority on Stable Connection preference is activated, the indicator on the neckband speaker flashes three times in blue. |